In-Situ Stress And Topography in 3DEC

3DEC is commonly used to model rock masses close to the earth’s surface. In these situations, the in-situ vertical stress at each point can be calculated from the weight of overlying material. The horizontal stresses often are assumed to be some proportion of the vertical.

3DEC provides a command, insitu topo, to calculate these initial stresses for each zone. However, this calculation used to be so slow that is was not of practical use. With the latest update of 3DEC (Version 5.00.168 or above), this function has been sped up dramatically to make it useful once again.

The figure below shows vertical stress calculated using the insitu topo command for a model with almost 800,000 zones. The calculation takes a couple of minutes, depending on the speed of your computer. You can see the higher stresses under the mountains and the lower stresses under the valleys. The red circle indicates a geological unit with low density. The zones under this unit therefore have reduced stresses.

The insitu topo command also calculates the stresses on joints as shown in the figure.

Download example


Dernières Nouvelles
  • Itasca has announced the release of FLAC2D v9 Itasca has announced the release of FLAC2D v9, revolutionizing the way we analyze and predict...
    En savoir plus
  • 6th Itasca Symposium on Applied Numerical Modeling The next Itasca Symposium will take place June 3 - 6, 2024, in Toronto, Canada....
    En savoir plus
  • Itasca International Inc. announces the Selection of its New CEO Itasca International Inc. announces the nomination of its new CEO ...
    En savoir plus

Évènements à Venir
13 mai
Getting Started With Dynamic Modeling in FLAC3D
This training supplies the tools needed to describe and apply the workflow for dynamic analysis in FLAC3D, demonstrating a comprehensiv... En savoir plus
8 mai
World Tunnel Congress 2025
This year the World tunnel congress 2025 is hosted in Sweden Stockholm. We are excited to meet all of you in Stockholm the 9-15th of Ma... En savoir plus
11 juin
Python in Itasca Software
Cette formation vous donnera toutes les clés pour être capable d’utiliser Python afin d'étendre les capacités de simulation des logicie... En savoir plus